MT625A & MT6260 (MTK USB Operations)

[kanniappan]

MT625A & MT6260 (MTK USB Operations)
 
 * How to Connect Mobile and Read Flash
 
Open Volcano Tool, Connect your mobile on volcano jig cable
 
Go to Detect tab and ddetect pinouts as shown in image below -
 
 
 
 
Press "Set pinouts" button and see in Device Manager Mtk Usb com port
 
 
 
 
 
Remove only Jig from mobile socket (Dont Remove Power cable)
Go to MTK tab
 
 
 
 
 
After Making above settings, Press RUN button, and when it says -
 
 "Analysis of USB port, Please insert phone USB cable."
 
Insert Jig cable back in mobile's socket
 
 
 
 
 
Flash Reading Completed.
 
 
==================================================  ====================

[kanniappan]

How to Connect Mobile and Write Flash after Reading Completed
 
Press Reset Pinouts Button (MTK usb port will again show-up)
 
 
 
 
 
Now Remove only Jig from mobile socket (Dont Remove Power cable)
 
Press RUN button, and when it says -
 
 "Analysis of USB port, Please insert phone USB cable."
 
Insert Jig cable back in mobile's socket
 
 
 
 
 
 
 
Flash Writing Completed.

[kanniappan]

How to Connect Mobile and Write IMEI after Flash Writing Completed
 
Remove both Volcano cable and power cable from mobile
go to detect tab, and press "Set pinout" button
 
 
 
 
 
Power ON mobile with battery, and connect volcano JIG only (not power cable)
Phone will give 2-3 options, select "COM port" -
 
 
 
 
 
A new MTK Usb port will form in device manager
Now go to MTK tab and do as -
 
 
 
 
 
Type IMEI, Select MTK Usb port Com, and press Write IMEI
 
 
 
 
 
IMEI Written.
 
 
 
 
 
IMEI Restore Completed.

[kishorech]

good  job nise