How to use PadFinder as CLIP?
Possibility to use PadFinder as Clip - absolutely unique feature for ALL MTK-processor based phones!Opportunity to use PadFinder as Clip for pinouts autodetection in ALL MTK CPU phones is a distinguishing peculiarity of our box and marks it out among the same kind of devices! This unique opportunity allows you to find the pinout WITHOUT STARTING SERVICE TOOL in several seconds!
Why it is usefull?
- You get the ONE BUTTON SOLUTION for ALL MTK-based phones ( handsets besed on other processor types are under permanent development now and will be added in further updates )!
- No need to start any service programs, choose cables and make settings for pinout autodetection
- Connects to PC via ordinary USB AB cable
- Pinouts are found at once and you get to work right away
- You can start the appropriate Service program for phone unlocking/flashing etc. right away ( For example, Multi-box "Chinese Cocktail" )
While your competitors are just preparing for work, you already HAVE the WORK DONE!
PROCEDURE OF USING PadFinder AS CLIP
1. Connect PadFinder to PC via ordinary USB AB cable
2. Remove phone battery!
3. Plug DB26 (26 pins) to "SPECIAL" socket.
4. Plug the appropriate phone connector to the phone input.
5. Using power wires from DB26 connect them insted of battery
"+" (red) power wire must be connected to phone "+" contact
"-" (black) power wire must be connected to phone "-" contact
6. PRESS and HOLD "MODE SELECT" button ( located near the "SPECIAL" socket of PadFinder ) for 7-8 seconds
* after you hold the button for 3 seconds you will see the YELLOW LED lighted - the box is in Command Mode, continue pressing
* after 5-6 seconds the RED LED will light - the box is ready to detect the pinout
7. STOP PRESSING "MODE SELECT" button after 7-8 seconds - the YELLOW LED will light again
8. PRESS and HOLD "Power On" button ON THE PHONE
9. The YELLOW LED will start blinking => it means that PadFinder searches the pinout
10. The RED LED will light => it means that PadFinder has found the pinout and you can release "Power On" button of the phone
NOTE: ALL THE PROCESS OF PINOUT AUTODETECTING TAKES APPROXIMATELY 20-25 seconds
