1112 convert to 1600 now contact service

[ratan4632]

I try to make My 1112 to 1600 by 7.02 MCU flash files. After flashing it showed "contact service". When I try again and again by Jaf and UFS-3 it failed to erase upto 54%. I also put some hit on UEM and POWER IC but same as before. Please give me the solution.


Thank you !
MONI
Dhaka, Bangladesh

[jtronics]

you dont need to hardware your unit.. just use jaf.. erase and flash.. if you hit uem i think it will cause another problem..

[Nayan1986]

I try to make My 1112 to 1600 by 7.02 MCU flash files. After flashing it showed "contact service". When I try again and again by Jaf and UFS-3 it failed to erase upto 54%. I also put some hit on UEM and POWER IC but same as before. Please give me the solution.


Thank you !
MONI
Dhaka, Bangladesh

Plz following the instruction...for resolving the 54% erase problem.!!

1.  plz chose ufsx for flashing

2. select the model and make skip erase from area 0
(it will show 9.make it 0)
3. select the both MCU & PPM & CNT file and press onto flash tab.

now it will flash ur handset properly...if flash complete then make a UI setting..wish ur phone will be ok.

[kamrulnet]

fast erase  Use 6.00 and again flash by Jaf

10000% ok

kamrul_satkhira
Nettelecom

[ismail0010]

thanks for the coments