3310 auto on/off

[prakashmborana]

i am use jaf+pkey v. 1.98.45   i flesh dct3 mobile 3310 with new version 6.3
after fleshing set faid unlock & fectory reset . but my 3310 on but no network and auto metic power off/on . i try vinring epprom but not working good and this mobile imei is also crupt i am not possible to built new imei.

please help me

[email protected]

[Remax]

Open your phone and see did phone water demaged,if not,try to upload full flash.
Regards

[prakashmborana]

but not solve this problem
i have 2100 i flesh v 5.49  this same problem

auto on/off   after than display SIM card not valid
prakash

[Jr_vill.]

try to reheat flash ic or change it.

[suriya narayanan]

Hai sir!
        1600 mobile very heat.....please solution

[geo_izak_88]

Hai sir!
        1600 mobile very heat.....please solution

Hi...

make a new thread for your problem sir,to answer you quickly..

To your Problem make a factory default using youre JAF or UFS...

regards

[venuskarthick]

i am use jaf+pkey v. 1.98.45   i flesh dct3 mobile 3310 with new version 6.3
after fleshing set faid unlock & fectory reset . but my 3310 on but no network and auto metic power off/on . i try vinring epprom but not working good and this mobile imei is also crupt i am not possible to built new imei.

please help me

[email protected]

bro for dct3 mobile,s always use ufs.......
jaf not supporthing properly

on ufs erace first
then write mcu+ppm+pmm files then make ui setthings & rebuild imei all will  done

[venuskarthick]

Hai sir!
        1600 mobile very heat.....please solution

witch componet is making short ckt cheak it first
if pf short means replace it
upp r uem means return it:)

[Qmad3]

but not solve this problem
i have 2100 i flesh v 5.49  this same problem

auto on/off   after than display SIM card not valid
prakash

sir first try to take out the flash ic then put a fresh one then flash it again do all the ui settings. reset phone , factory set edit the imei . just use the old imei . better use the nok pheonix . ok good luck bro.

[Qmad3]

Hai sir!
        1600 mobile very heat.....please solution

check your uem if not shorted if shorted check your power amp

[Qmad3]

i am use jaf+pkey v. 1.98.45   i flesh dct3 mobile 3310 with new version 6.3
after fleshing set faid unlock & fectory reset . but my 3310 on but no network and auto metic power off/on . i try vinring epprom but not working good and this mobile imei is also crupt i am not possible to built new imei.

please help me

[email protected]

sir change the audio ic also known as cobba ic then go to nok tools by bphreaks then set it to full factory  , input the corresponding imei. unlock it done.

[britz23]

check ur cobba/audio ic

[swn08]

Nokia 2626 hang problem please help me

[tharak]

mcu+ppm+cnt files from 3310

[vtsolution]

Hai sir!
        1600 mobile very heat.....please solution

chang d terminal & servic d phone